Downloading An Application - ABB CP415 Installation And Operation Manual

6.6

Downloading an Application

Connect the RS232 port on the PC to the COM1 port on the CP415 using a
TK401 cable. The connection can also be made according to the illustration be-
low:
CP415
COM1
9-pin male
RXD 2
TXD 3
GND 5
RTS 7
CTS 8
Warning:
To avoid an electrical shock, be sure to switch off the power before connecting the
download cable to the operator terminal.
Set the dip switch SW7 = ON. After the self-test, the system menu will be
displayed on the screen and the operator terminal is ready to download the
application.
Start CP400Soft and open the application file to be downloaded. Make sure that
the communication parameters are correctly configured. Also remember to
compile the file before downloading it. The file has to be compiled every time a
change has been made in the file before downloading it.
Then select Application/Download Firmware/Application in CP400Soft if it is
a first time to download the application to the operator terminal; otherwise, se-
lect Application/Download Application. The following appears on the screen
while the operator terminal is downloading:
ABB, 1SBC159107M0201
PC
RS232
9-pin female 9-pin male
2 RD RS485+ 1
3 SD RS485- 6
5 SG
1 CD
4 DTR
6 DSR
7 RTS
8 CTS
CP415
COM1
Operation
IPC485 or RS485
interface
converter
D+
D-
19