Introduction; Regulation And Standards - Magellan MARS-1-2-4-6 User Manual

1.Introduction

Thank you for your recent purchase of a Magellan RFID reader-writer.
This User Manual will provide you with information to rapidly adopt
Magellan's PJM technology for your needs, to install the Reader hardware
and ReaderManager software and get the Reader running.
Refer to the ReaderManager Guide (40-01-006-DOC) for a description of
the various tools and advanced options available in the ReaderManager
software.
Programming is covered in the Application Programmer's Guide (40-01-000-
DOC).

1.1Regulation and Standards

RFID equipment is subject to national and international regulations.
FCC Radio Frequency Interference Statement (USA)
The FCC regards RFID equipment as low-power transmitting devices and,
therefore, does not require users of RFID devices to obtain a license to
operate them.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to
radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:




!
FCC ID: TVN-Mars-1
Industry Canada Radio Frequency Interference Declaration of Conformity (Canada)
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003
du Canada.
ICES\NMB-003 IC: 6596A-Mars1
MARS-1-2-4-6 USER MANUAL
Reorient or relocate of receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications to the equipment that are not
expressly approved by the party responsible for compliance
could void the user's authority granted under FCC Rules to
operate this equipment.
3 64-70-017-DOC ver.1