Connecting To A Power Supply - Magellan MARS-1-2-4-6 User Manual

4.1.1Connecting to a power supply

Step 1. Connect a low voltage power pack to the unit.
The connection to the power source is realized via a low voltage power
pack.
Step 2. Plug the power supply into AC power mains. LEDs will come on.
When power is applied to an MARS Reader the LEDs on the Reader should
operate as follows:


MARS-1-2-4-6 USER MANUAL
The power cable is not supplied with the Reader
and recommended to be purchased in the country
of use.
the red LED and green LED
go off in about 1 minute
MARS with the red and green LEDs on
the red LED will come on again in 1-3 seconds indicating that the
Reader is in an operational mode; the
MARS with the red LED. The Reader is in an operational mode
will immediately come on; both LEDs will
green LED will be off
23 64-70-017-DOC ver.1