Electrical Connection - Whirlpool WDT975SAHV Installation Instructions Manual

Undercounter dishwasher stainless steel tub
Hide thumbs Also See for WDT975SAHV:
Table of Contents

Advertisement

Available languages

Available languages

5.
Built-up floors –
add shims as needed
Built-up floors: If the kitchen floor is higher than the cabinet
opening's floor - for example, the kitchen floor tile does not
extend into the cabinet opening - add shims, as needed, in the
area shown to bring the dishwasher up to 34" (864 mm) below
the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
6.
Remove foam block
Remove and discard the foam blocks (if blocks are present;
not all models have them) located above the front legs on
each side of the dishwasher. The blocks cover the rope/link
pulleys on the dishwasher.
10
29-Aug-2018 12:50:53 EDT | RELEASED
If installing into a
33
Cut insulation blanket along perforation for cabinet opening
height of 33
do not cut the insulation blanket.

ELECTRICAL CONNECTION

– For Direct Wire, begin with Step 7
– For Power Cord, wait until Step 22
7.
Foam block
If installing with direct wire, route the cable as shown.
Route cable from power supply through cabinet hole. (Cable
must extend to the right front side of cabinet opening.) Tape
cable to the floor in area shown. This will prohibit cable from
moving when dishwasher is moved into cabinet opening.
NOTE: If removing a previous dishwasher with a power cord,
you will need to transfer the power cord to the new dishwasher.
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
/
" (851 mm) opening
1
2
/
" (851 mm). For other cabinet opening heights,
1
2
Direct wire – route cable

Advertisement

Table of Contents
loading

Table of Contents