Whirlpool WDT975SAHV Installation Instructions Manual page 23

Option B: No waste disposer –
no air gap
Waste tee
1. Fit rubber end of drain hose
1
Rubber
end
2. Attach rubber end of drain hose to
2
29-Aug-2018 12:50:53 EDT | RELEASED
Large drain
hose clamp
Drain hose
Drain trap
to waste tee and cut if needed.
NOTE: Do not cut ribbed section.
waste tee with a large drain hose clamp
(provided). Use pliers to squeeze clamp
open and move into position. If the drain
hose was cut, use a 1 / " to 2" (38 to
1
2
50 mm) screw-type clamp (not provided).
In some European factories the letter "W" of the part code mentioned herein will be automatically
Option C: Waste disposer – with air gap
Screw-type clamps
Disposer inlet
Drain trap
Helpful Tip: Remove disposer knockout plug.
1. Using a hammer and screwdriver, knock
1
plug into disposer.
2. Use needle-nose pliers to remove plug.
2
3. Connect rubber end of drain hose
3
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
Rubber
end
4 4. Attach drain hose to air gap with large
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position. If the drain hose was cut, use
a 1 /
1
2
clamp (not provided).
5 5. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from air gap to disposer inlet.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Air gap
Large drain
hose clamp
Rubber hose
connector
Drain hose
" to 2" (38 to 50 mm) screw-type
23