Installation Instructions; Prepare Cabinet Opening - New Utilities; Install Optional Moisture Barrier - Whirlpool WDT975SAHV Installation Instructions Manual

Undercounter dishwasher stainless steel tub
Hide thumbs Also See for WDT975SAHV:
Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION INSTRUCTIONS

Electrical Shock Hazard
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
Failure to do so can result in death or electrical shock.
1.
Disconnect power
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
2.
Shut off water supply
Shut off the water supply to the dishwasher.
PREPARE CABINET OPENING –
NEW UTILITIES
3.
Drill hole locations -
new construction
Optional
location
1
/
"
1
2
(38 mm)
NOTE: Refer to the "Product and Cabinet Opening
Dimensions" section for the correct hole placement and
dimensions of the shaded area.
Drill a 1
/
" (38 mm) drain hose hole in the side or rear of
1
2
cabinet, depending on location of drain hose routing and
drain hose connection location.
Drill a
/
" (12.7 mm) water supply hose hole in the side or
1
2
rear of cabinet, depending on location of water supply
routing and connection location
Drill a 1
/
" (38 mm) electrical conduit hole in the right-hand
1
2
side or rear of cabinet.
29-Aug-2018 12:50:53 EDT | RELEASED
WARNING
Preferred
location
1
(12.7 mm)
In some European factories the letter "W" of the part code mentioned herein will be automatically
4.
Sand holes smooth
Wood
cabinet
Wood cabinet: Sand the hole until smooth.
Metal cabinet: Cover edges of hole with grommet included
with power cord kit. See the "Tools and Parts" section at
the front of the guide for part details.
Helpful Tip: Wiring the dishwasher will be easier if you route
the cable into the cabinet opening from the right-hand side.
INSTALL OPTIONAL MOISTURE BARRIER –
RECOMMENDED FOR WOOD COUNTERTOPS
Moisture barrier/wood shims
/
"
2
See the "Tools and Parts" section at the front of the guide for
part details and orders. Make sure the area under the cabinet
is clean and dry for installation of the moisture barrier. Remove
the backing of the moisture barrier, and apply to underside of
the countertop along the front edge of the counter.
NOTE: Install wood shims if side anchoring and the gap
between the sides of the cabinet and sides of the dishwasher
are greater than
the length of the side anchor screws.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Moisture
barrier
Install
wood
shims
/
" (12.7 mm) on each side or are greater than
1
2
Metal
cabinet
9

Advertisement

Table of Contents
loading

Table of Contents