®
™
Anybus
Communicator
- EtherNet/IP
8.2. Communicator LED Indicators
NOTE
Before you can verify operation you must configure the Communicator.
Figure 37. Gateway status (A), Lower connector (B), Upper connector (C) and (D) Security Switch
LED A - Gateway status
Operation Status
Off
Green, flashing
Green, solid
Red, solid
Red, flashing
Green/Red, flashing
LED B - EtherNet/IP, Upper connector
Operation Status
EtherCAT
Off
No power/EtherCAT device
in 'INIT'-state
Green, flashing
EtherCAT device in 'PRE-
OPERATIONAL'-state
Green, one flash
EtherCAT device in 'SAFE-
OPERATIONAL'-state
Green, solid
EtherCAT device in
'OPERATIONAL'-stat
*The EtherCAT RUN (green) and ERROR (red) LED behaviors are combined in LED (C)/(D). This can cause LED (C)/(D) to alternate between red and
green. The LED behavior still represents the states described in the table above.
Page 44 of 60
™
Adapter to PROFIBUS DP Device
Description
No power
Startup phase
Operational
Exception/Fatal error
Invalid configuration
Power up self-test/Firmware update/Firmware recovery
EtherNet/IP
No power/No EtherNet/IP
IP address
EtherNet/IP online, no
connections established
N/A
EtherNet/IP online, one
or more connections
established
Communicator LED Indicators
Modbus TCP
PROFINET
No power/ No Modbus TCP
No power/No connection
IP address
with IO controller
Modbus TCP online, no
Used by engineering tools
messages received
to identify the node on the
network
N/A
Connection with IO
controller established
IO controller in STOP state
or IO data bad
Modbus TCP online, at least
PROFINET online, one
one message received
or more connections
established
SCM-1202-200 Version 1.0