Definitions For Illuminated Lcd Indicators; Estimated Runtime - CyberPower CST150XLU User Manual

DEFINITIONS FOR ILLUMINATED LCD INDICATORS

1. INPUT Voltage Meter:
This meter measures the AC voltage that
the UPS system is receiving from the
utility wall outlet. The UPS is designed to
continuously supply connected equipment
with stable output voltage. In the event of a
complete power loss, severe planned power
suppression, or over-voltage, the UPS relies
on its internal battery to supply consistent
110/120 output voltage. The INPUT voltage
meter can be used as a diagnostic tool to
identify poor-quality input power.
2. OUTPUT Voltage Meter:
This meter measures, in real time, the AC
voltage that the UPS system is providing
to the computer during normal AC/Utility
Power mode, and battery backup mode.

3. ESTIMATED RUNTIME:

This displays the run time estimate of the
UPS with the current battery capacity
and load.
4. NORMAL Icon:
This icon appears when the UPS is working
under normal conditions.
5. BATTERY Icon:
During a severe planned power suppression
or power outage, this icon appears and an
alarm sounds (two short beeps followed by
a pause) to indicate the UPS is operating
from its internal batteries. During a
prolonged planned power suppression
or power outage, the alarm will sound
continuously to indicate the UPS's batteries
are nearly out of power. You should
save fles and turn of your equipment
immediately or allow the software to shut
the system down.
6. AVR (Automatic Voltage Regulation) Icon:
This icon appears whenever your UPS
is automatically correcting low AC line
voltage without using battery power. This is
a normal, automatic operation of your UPS,
and no action is required on your part.
7. SILENT MODE Icon:
This icon appears whenever the UPS is in
silent mode. The buzzer does not beep
during silent mode until the battery reaches
low capacity.
8. OVERLOAD Icon:
This icon appears and an alarm sounds to
indicate the battery-supplied outlets are
overloaded. To clear the overload, unplug
some of your equipment from the battery-
supplied outlets until the icon turns of and
the alarm stops.
9. FAULT:
F01: Battery Mode or AC/Utility Power
Mode Overload fault (Unplug at least one
piece of equipment from battery outlets
and turn the UPS on again.)
F02: Battery Output Short fault (Unplug at
least one piece of equipment from battery
outlets and turn the UPS on again.)
F03: Charger Fault (Contact CyberPower
Systems for support.)
F04: Internal Fault (Contact CyberPower
Systems for support.)
10. BATT. CAPACITY Meter:
This meter displays the approximate charge
level (in 20% increments) of the UPS's
internal battery. During a power outage
or severe planned power suppression,
the UPS switches to battery power, the
BATTERY icon appears, and the charge
level decreases.
11. LOAD CAPACITY Meter:
This meter displays the approximate output
load level (in 20% increments) of the UPS
battery outlets.
The LCD display indicated a
variety of UPS operational
conditions. All descriptions
apply when the UPS is
plugged into an AC outlet
and turned on or when the
UPS is on battery.