Advertisement
HOW TO USE THE CLEANER
To set up:
Be sure the ultrasonic cleaner is unplugged. Always unplug the unit before filling or emptying
gas from the solution.
To clean parts:
1. Place objects to be cleaned in the plastic basket. Items should not be placed
directly on the tank bottom.
2. Suspend the basket in the cleaning solution. Cleaning is usually complete in 30
seconds to 2 minutes depending on the type and amount of soil. The cleaner automatically
shuts off after 5 minutes. The unit can be shut off during the cleaning cycle by pressing the
-
3. Rinse parts under running tap water and dry if necessary.
To be safe:
1. When cleaning items for the first time, test one piece before cleaning the rest.
2. Be sure that the cleaning solution you use is compatible with the stainless steel cleaner tank.
3. Follow instructions and precautions recommended by the cleaning solution manufacturer.
4. Avoid contact with solutions and provide adequate ventilation.
5. To avoid possible discomfort, do not put fingers into the tank while the ultrasonic cleaner is
operating.
6. Never use solvents or flammable liquids in the ultrasonic cleaner.
7. If you clean items with movable parts, you should consider re-oiling immediately after cleaning.
8. Do not operate the cleaner without liquid in the tank.
9. It is normal for your cleaner to become warm after 10-15 minutes of continuous operation
Fill the tank to within 1cm of the
top edge with warm water. Be sure to leave
room for your chemistry and parts. The liquid
level should not be allowed to drop below 1cm
from the tank bottom
Plug the cleaner into an appropriate
outlet. This would be 110-120 volts
in the U.S. and 220 volts in Europe.
Check the label on your unit and
use only that voltage.
for several minutes to drive excess
Advertisement
