Troubleshooting; Warranty; Disposal - Dometic Power & Control PJS1000 Operating Manual

PJS1000

10 Troubleshooting

Fault
The jump starter does not
work. The button
does not respond.
The vehicle is not jump-
started.

11 Warranty

The statutory warranty period applies. If the product is defective, please contact your retailer or the manufacturer's
branch in your country (see dometic.com/dealer).
For repair and warranty processing, please include the following documents when you send in the product:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
Note that self-repair or non-professional repair can have safety consequences and might void the warranty.

12 Disposal

Recycling packaging material
➤ Place the packaging material in the appropriate recycling waste bins wherever possible.
EN
Possible cause
The jump starter is deeply
discharged.
Insulation faults, breaks or
loose connections at the
live cables.
Low voltage protection of
the jump starter
Over current protection of
the jump starter
Short circuit protection of
the jump starter
The battery is significantly
sulfated.
The jump starter is less
than 50 % charged.
The battery clamps are
loose or not connected
correctly.
The battery terminals are
dirty or corroded.
Suggested remedy
➤ Charge the jump starter (see chapter "Charging
the jump starter" on page 15).
➤ Check live cables for insulation faults, breaks or
loose connections.
➤ If you cannot find an error, contact an authorized
service agent.
➤ Charge the jump starter (see chapter "Charging
the jump starter" on page 15) to reactivate it.
➤ Remove the load from the USB or 12 V DC output.
Charge the jump starter (see chapter "Charging
the jump starter" on page 15) to reactivate it.
➤ Remove the load from the USB or 12 V DC output.
Charge the jump starter (see chapter "Charging
the jump starter" on page 15) to reactivate it.
➤ Replace the battery.
➤ Charge the jump starter (see chapter "Charging
the jump starter" on page 15).
➤ Check the connections. Ensure that the battery
clamps are firmly secured and connected cor-
rectly. Reconnect if necessary.
➤ Clean the battery terminals and reconnect the
jump starter.
Troubleshooting
19