Cleaning And Maintenance - Dometic Power & Control PJS1000 Operating Manual

Cleaning and maintenance

✔ The LCD display shows the remaining state of charge of the jump starter.
8.8 Operating 12 V devices
I
NOTE
Operation of 12 V devices is not possible while the jump starter is being charged.
➤ To operate 12 V devices, connect the power cable of the 12 V device to the 12 V DC output of the jump starter
(fig. 2 4, page 4).
✔ The LCD display shows the remaining state of charge of the jump starter.
8.9 Wireless charging
I
NOTE
Ensure your device supports wireless charging.
➤ To wireless charge devices, press the
fig. 9, page 8.
➤ The LCD display shows the remaining state of charge of the jump starter.
9 Cleaning and maintenance
!
WARNING!
Unplug the device from the power supply before each cleaning and maintenance.
A
NOTICE! Damage hazard
• Never clean the device under running water or in dish water.
• Do not use sharp or hard objects, abrasive cleaning agents or bleach during clean-
ing as these can damage the device.
➤ Occasionally clean the device with a soft, damp cloth.
➤ Regularly check live cables or lines for insulation faults, breaks or loose connections.
➤ Regularly check the state of charge of the device battery. Charge the battery after each use and at least every
3 – 6 months, even when not in use.
18
button and place your device on the wireless charging pad, see
PJS1000
EN