Safety Instructions - Dometic Power & Control PJS1000 Operating Manual

Jump starter with power bank
Hide thumbs Also See for Power & Control PJS1000:
Table of Contents

Advertisement

Safety instructions

I
NOTE
Supplementary information for operating the product.
2 Safety instructions
Also observe the safety instructions and stipulations issued by the vehicle manufacturer and autho-
rized workshops.
2.1 General safety
!
WARNING! Failure to obey these warnings could result in death or serious
injury.
Electrocution hazard
• Do not operate the device if it is visibly damaged.
• The jump starter may only be repaired by qualified personnel. Improper repairs can
lead to considerable hazards.
• Do not disassemble the device.
• Do not modify or adapt any of the components in any way.
• Only use accessories and spare parts that are recommended by the manufacturer.
• Do not use the device in wet conditions or submerge in any liquid. Store in a dry
place.
• Switch off the device and disconnect it from the power supply:
– After every use
– Before each cleaning and maintenance
Risk of asphyxiation
• The cable and control unit of the device can give rise to risks of entanglement, stran-
gulation, tripping or treading if not correctly arranged. Ensure that excess ties and
power cables shall be arranged in a safe way.
Health hazard
• This device can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and know-
ledge if they have been given supervision or instruction concerning use of the device
in a safe way and understand the hazards involved.
• Electrical devices are not toys.
Always keep and use the device out of the reach of very young children.
• Children must be supervised to ensure that they do not play with the device.
• Cleaning and user maintenance shall not be made by children without supervision.
A
NOTICE! Damage hazard
• Before start-up, check that the voltage specification on the data plate is the same as
that of the power supply.
• Ensure that other objects cannot cause a short circuit at the contacts of the device.
• Ensure that the negative and positive poles never come into contact.
• Do not use the cables as a handle.
10
PJS1000
EN

Advertisement

Table of Contents
loading

Table of Contents