Table of Contents
Advertisement
6 Display
The N2KMeter LCD display includes a large 3-digit display as well as 17 other indicators that
are shown in the following diagram.
1
Network Node Address (node #) or N2KMeter switch setting number (AutoSearch)
Display Locked indicator ("lock" switch is on)
2
3
Measurement displayed is acceptable
4
Measurement displayed is marginal
5
Measurement displayed is unacceptable
Battery low – stored measurements may be lost
6
7
125 Kbaud network activity detected
8
250 Kbaud network activity detected
9
500 Kbaud network activity detected
10
Measurement unit is % bandwidth
11
Measurement unit is errors / messages per second
12
Measurement unit is volts
13
Measurement displayed is in thousands (kilo)
14
Measurement displayed is a maximum value
15
Measurement displayed is a minimum value
16
Measurement displayed is a peak-to-peak value
17
Displayed when viewing measurements for a particular Node Address. Not displayed
in AutoSearch mode when the value shown in the top left corner is a switch position.
NOTE: If none of MIN, MAX or P-P is shown then the value displayed is a "live" measurement
or the most recent "Live" measurement if the "lock" switch is on.
Page 6
Revision 1.3
Advertisement
Table of Contents
