Table of Contents
Advertisement
17 Switch Settings
The N2KMeter has two configuration switches located in the battery compartment. The Meter
Power switch (on left) selects between bus/battery power (powered by bus when available) and
battery only power. Selecting battery-only power eliminates the possibility of inadvertently
contributing to common mode voltage problems on extremely long networks, but limits the
N2KMeter use to about 7 hours on fresh batteries.
The Alarm Sound switch (on right) enables and disables the "beep on error/transient" feature.
With this feature enabled, the N2KMeter beeps each time a bus error or transient occurs when
the selector switch is in the corresponding position.
18 Certifications
This device meets or exceeds the requirements of the following standard(s):
UL3111-1 Can/CSA C22.2
CAT II 30V
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference, in which case the user will be required to correct the interference
at his own expense.
Revision 1.3
Page 25
Advertisement
Table of Contents
