Table of Contents
Advertisement
5 Using the N2KMeter
5.1 Viewing Measurements
Each selector switch position accesses a different bus measurement, and each supports several
different measurement types.
Pressing
cycles the display through the different measurements available at each switch
position.
Some measurements allow a detailed view for each Node Address. Press
through the active Node Addresses. Press
view.
5.2 Display Lock
To lock measurements for offline viewing, move the lock switch to the
values and restart bus analysis move the lock switch to "Run".
Stored values are retained indefinitely, providing the lock switch is left in the
batteries are good - even if the meter is turned off.
5.3 Resetting Min/Max Measurements
The N2KMeter is reset (Min/Max and other stored measurements cleared) when the Lock switch
is moved to the "Run" position, and when the power switch is turned On while the Lock switch is
in the "Run" position.
You may reset stored measurements by either turning the meter off and on again, or by moving
the Lock switch to
Revision 1.3
and back to "Run".
LCD Display
Pushbuttons
Next Measurement
Next Node Address
Previous Node Address
Return to Network View (push at
the same time)
Selector Switch
AND
together to return to the overall network
OR
to cycle
position. To erase stored
position, and the
Page 5
Advertisement
Table of Contents
