Adjusting Cutting Angle - Shindaiwa AH243S Operator's Manual

Before you start
1. Throttle cable
2. Cable adjuster
3. Ignition leads
1. Throttle cable
2. Connect end of Throttle cable here
1. Ignition leads

Adjusting Cutting Angle

Adjusting the hedge trimmer cutter assembly
1. Adjustment lever
2. Loop the ribbed cable tube under the tube and to the top left
side of the engine and push cable through the cable adjust-
er.
NOTE
Make sure the ribbed cable tube is on the left side of the engine
before connecting the throttle cable.
3. Connect the bullet shaped end of the throttle cable to the
throttle lever on top of the carburettor.
4. Connect ignition leads.
Wiring runs must not interfere with throttle operation.
Wear heavy duty gloves when working with the hedge
trimmer blades. When replacing the hedge trimmer
blades during a trimming task, ensure that the engine is
switched off and that the blades have stopped.
Failure to do so could lead to an injury or serious accident,
or cause a fire.
1. Position the hedge trimmer on a flat, level surface with the
engine resting on the fuel tank guard. Make sure the scab-
bard is in place on the blade.
16
CAUTION
WARNING