Shindaiwa AH243S Operator's Manual page 23

1. Starter handle
Engine warm-up
Starting a warm engine
1. Ignition switch
2. Throttle trigger
1. Choke lever
2. Cold Start
3. Throttle trigger lockout
4. Start
3. Run
Engine operation
1. Once the engine starts, allow it to warm up for 2 to 3 minutes
at idling (i.e. low speed).
2. Warming the engine helps to lubricate its internal workings
more smoothly. Allow the engine to warm up fully, especially
when it is cold.
1. Move the ignition switch to the Start position.
2. Make sure that the throttle trigger is at the idle speed posi-
tion.
3. Check that the choke lever is in the "Run" position.
4. If fuel tank is not empty, pull on the starter grip to start the
engine.
5. If no fuel is visible in the purge bulb, alternately press and re-
lease the purge bulb until the fuel is sucked up into it.
6. Checking that the area around you is safe and pull on the
starter grip to start the engine.
21