Braun Sensation CP 1600 AA1 Manual page 7

B Attaching the Braun
sensation attachment
1. First align the arrows on the rim of the
attachment and on the air outlet of the hair-
dryer.
2. Push the attachment onto the hairdryer,
then turn until it clicks into place.
3. Push switch
1d
securely lock the attachment on the hair-
dryer.
4. Push switch
1d
establish the electric connection between
the hairdryer and the attachment. When
switching the hairdryer on, the volume plate
automatically vibrates.
To stop the vibration, simply push switch
back to position « 0 ».
To take off the attachment, first move switch
back to position
1d
attachment until the arrows are aligned and
take it off.
C Using the volume plate
for maximum volume in
straight styles
1 Place the volumising fingers on your scalp.
1 Gently move the attachment through your
hair so that the hair is lifted. The active
motion (vibration) of the volume plate helps
the hair climb between the fingers and
keeps it tangle-free as it is dried.
1 Then, hold the attachment in place until
the hair is dry and has reached the desired
volume.
1 The volume plate is also ideal for untangling
long hair.
1 To remove the volume plate, firmly press
the outer rods together and take it off.
to position « 0 » in order to
to position «1» to
, then turn the
D Using the diffusor plate
for full volume curls and
gentle drying
1 To attach the diffusor plate, place it onto
the motor part and press it down with your
flat hand until it clicks into place.
1 Slowly guide the diffusor plate over your
scalp to create volume and root lift.
1 If you have long hair, first dry hair ends by
placing them onto the diffusor plate.
1 Then carefully lift the hair with the diffusor to
your head and hold. Continue section by
section.
1 Finish off the roots by carefully moving the
diffusor plate over the scalp to add some lift.
1d
1 To remove the diffusor plate, press
the release handles.
E Cleaning
Always unplug the appliance before
cleaning. Remove the attachment
described above.
To clean the volume plate or the diffusor
plate with water, always remove them from
the motor part
with a damp cloth only. Before putting a
plate (
1a
is dry.
Cleaning the filter
Regularly wipe the filter
the air inlet free from dust and hairs.
The filter is detachable and can be cleaned
under running water.
Subject to change without notice.
This product conforms to the EMC-
Requirements as laid down by the
Council Directive 89/336/EEC and to
the Low Voltage Regulation (73/23 EEC).
. Clean the motor part
1c
or ) back on, make sure it
1b
in order to keep
4
as
1
7