Fintek OSLO 4.2 Installation Manual. Instructions For Use page 84

FIG.1
SYDNEY / KYOTO
OSLO 4.0/4.2
PANAMA
METROPOLIS 10/12 HP
FIG.2
FIG.3
84 OSLO 4.2
ELECTRONIC SYSTEM CONNECTION
NO CONDENSATE DRAIN
To connect the electronic condensate disposal system already mounted
on the machine, it is not necessary to drill any other additional holes on
the wall or on the installation surface of the air conditioner.
After drilling the holes on the wall for the inlet and expulsion of air
from the side of the supply fan, you will find the delivery nozzle as
shown in FIG.1
Then connect the Rilhsen tube supplied and check that it adheres per-
fectly without the possibility that it can be removed, alternatively, use
special adhesives to ensure a perfect seal on the nozzle.
Connect the other end of the pipe to the expulsion grid as shown in the
figure, after measuring it for the length of the hole drilled by adding
+ 7cm for assembly flexibility. (FIG.2 / FIG.3) Secure the grid and posi-
tion the air conditioning unit in the following,leaving you some space
to operate. NOTE: it can make a few drops ,of bigger water during the
shutdown phase. Maintain at least every ,6 months
N: B: it can make a few drops of larger water during shutdown.
Maintain at least every 6 months.
The final result will be the following according to the type of grid adopted:
N.B. THE NO-CONDENSATE DRAIN
KIT SYSTEM COULD INCREASE THE
ENVIRONEMENT NOISE. DURING
THE AIR COND SHUTDOWN, SY-
STEM WILL DISCHARGE ALL RE-
MAING CONDENSATE IN THE TANK.
THEREFORE ENVIRONEMENT NOI-
SE FOR A FEW SECONDS COULD BE
USUAL FOR A WHILE