iHome Zenergy CANDLE ZBT110 - Portable Bluetooth Sound Soother Manual
WHAT'S IN THE BOX
Instructions
USB Charging Cable
iZBT110 Zenergy Candle
FRONT PANEL
- Sound Therapy Modes
- Power ON/OFF
- Light Therapy Modes
BACK PANEL
- Minus Button
- Plus Button
- Charging LED
- Micro USB Charging Port
- Reset Button
- Bluetooth Pairing Button
- Sleep Timer Button
- Timer LED
- Bluetooth Pairing LED
GETTING STARTED
Charging the Unit
CHARGE BEFORE USE
Connect one end of the included USB charging cable to the USB Charging Port on the back of the unit. Connect the other end to a USB AC adapter (not included) or the USB charging port on your computer/laptop.
Charging LED Status:
- Flashing Red LED: Unit is charging.
- Slow Blinking Red LED: Battery low. Charge unit.
- LED OFF: Unit is fully charged.
Connecting to Bluetooth
- Press the Power Button to turn the unit ON.
- Press and hold the Bluetooth Pairing Button until the blue LED flashes to enter pairing mode.
- Select 'iHome iZBT110' on your device's Bluetooth menu to connect.
USING LIGHT THERAPY
Color light therapy can enhance the home through ambient or night-time lighting to help improve mood, energy and sleep.
- Press the Light Therapy Button to access Light Therapy mode. Continue to press as needed to cycle to each mode, including OFF:
Candle:
|
Provides the ambiance of a calming candle flicker without the safety risks posed by a real flame
|
Nightlight:
|
Deal for illuminating a small space
|
Glow:
|
A gentle fading spectrum of solid colors creates a beautiful atmosphere for day or night mood lighting
|
One Color:
|
Select the current color
|
Pulse:
|
Light pulses to Bluetooth audio
|
ADJUSTING THE BRIGHTNESS
When you turn on Light Therapy or change a light mode, press the - or + Buttons within 5 seconds to adjust the brightness level.
Press and hold the Light Therapy Button for 2 seconds to exit light therapy mode. Press the Light Therapy Button again to resume mode at the last light pattern used.
USING SOUND THERAPY
Sound Therapy uses specially recorded and engineered sounds to cancel out distractions and allow your mind to calm.
- Press the Sound Therapy Button to access Sound Therapy mode. Continue to press to cycle to each mode:
Sound Therapy Modes:
- 4-7-8 Breathing Coach
- Zen
- Meditation
- Storm
- Wind
- Chimes
- Quiet
- Dream
- Trance
- Nature
- Air
- Drive
- Peace
- Ocean
- River
- Focus
- Off
- Press and release the – or + Buttons to adjust speaker volume.
- Press and hold the Sound Therapy Button for 2 seconds to exit sound therapy mode.
Note: After 60 minutes of no sound or light activity, unit will automatically power OFF. To resume operation, press the Power Button.
USING THE SLEEP TIMER
The programmable timer mode lets you set any combination of light and sound therapy for a set duration. The light and sound levels will gradually decrease over the last 15 minutes (fade begins right away if timer is set to 10 minutes or less) until the unit shuts off.
Press the Sleep Timer Button as needed to cycle to the desired timer duration: 10 minutes, 30 minutes, 1 hour, 2 hours, 4 hours, 6 hours, 8 hours, or OFF.
Timer mode is first indicated by a voice guide and the Timer LED next to the Timer button. Green indicates more than 60 minutes remaining, yellow indicates 30 minutes or less remaining and red indicates 10 minutes or less remaining.
Press and hold the Timer Button for 2 seconds to cancel timer mode. Timer mode is inactive when no timer indicator is lit.
CONNECTING + PLAYING BLUETOOTH AUDIO
Stream Bluetooth audio through the speaker in the unit:
- Press and hold the Bluetooth Pairing Button to enter pairing mode. The Bluetooth LED will flash.
- Select 'iHome iZBT110' on your Bluetooth device to connect.
- The Bluetooth LED will glow solid to confirm a device is connected.
- Use the controls on your device to Play, Pause, and navigate tracks.
- Use the + and - Buttons on the unit to control volume.
RESETTING THE UNIT
In the event of interrupted operation, use the extended tip of a paper clip or other thin tool to press in the Reset Button pinhole located on the back of the unit.
MAINTENANCE
- Place the unit on a level surface away from sources of direct sunlight or excessive heat.
- Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material should be placed between it and the furniture.
- Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents such as thinner or similar materials can damage the surface of the unit.
WARNING/DISPOSAL OF UNIT
Do NOT attempt to change the battery. Doing so will void the warranty and could cause injury and damage to your device. To dispose of the unit, follow the instructions below:
- Never dispose of used batteries/electronics with ordinary solid wastes, since they contain toxic substances.
- Always dispose of used batteries/electronics in accordance with the prevailing community regulations.
- Many electronics retailers now recycle batteries and other electronic components at no charge
GENERAL BATTERY PRECAUTIONS
- Never use or charge a battery if it appears to be leaking, discolored, deformed, or in any way abnormal.
- Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or other electrolytic substances.
- Avoid charging a rechargeable battery when the temperature is not within 5°C - 35°C (41° - 95°Fahrenheit).
- Never expose a battery to any liquid.
- Never expose a battery to excessive heat such as direct sunlight or fire.
- Never use a battery pack in an unventilated vehicle where excessive internal temperatures may be encountered.
- Always keep batteries out of the reach of infants and small children,
IMPORTANT SAFETY INSTRUCTIONS
Please heed all warnings, read and follow all instructions and keep these instructions handy for future reference.
- Do not use this product near water, and clean only with dry cloth.
- Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
- Heat – This product should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat.
- Only use attachments/accessories specified by the manufacturer.
- Unplug this product during lightning storms or when unused for long periods of time.
- Damage Requiring Service – This product should be serviced by qualified service personnel when:
- Plug has been damaged.
- Objects have fallen into or liquid has been spilled into the enclosure.
- The unit has been exposed to rain. The unit has been dropped or the enclosure damaged.
- The unit exhibits a marked change in performance or does not operate normally.
- No naked flame sources, such as lighted candles, should be placed on this product.
- Attention should be drawn to the environmental aspects of battery disposal.
- This product is suitable for use in tropical and/or moderate climates.
To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
- Do not dispose of batteries in the household trash or fire.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
- If the unit is to be unused for an extended period of time, such as a month or longer, charge the unit fully before storage.
- Always use a UL/ETL certified charging adapter (not included), and the supplied USB charging cable.
Documents / ResourcesDownload manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download iHome Zenergy CANDLE ZBT110 - Portable Bluetooth Sound Soother Manual
Need Assistance?
Do you have a question about the Zenergy CANDLE iZBT110 that isn't answered in the manual? Leave your question here.