iHome PLAYFADE iBT400 - Portable Bluetooth Speaker Manual

OVERVIEW

1. BLUETOOTH STATUS LED
   • Flashes while in pairing mode
   • Solid when connected
2. VOLUME DOWN
   • Press to decrease volume
3. PLAY/PAUSE
   • Press to play/pause audio
4. VOLUME UP
   • Press to increase volume
5. POWER ON/OFF
   • Press & hold to turn speaker ON/OFF
6. BLUETOOTH PAIRING
   • Press & hold to enter pairing mode
   • Select 'iHome iBT400' on your device to connect

REAR CONTROLS

1. USB CHARGING PORT
2. CHARGING STATUS LED

   	RED	charging (slow flash)
   	OFF	fully charged
   	RED	low battery (fast flash)

3. RESET BUTTON
   Insert the tip of a paper clip or other thin tool to reset

CHARGING THE SPEAKER

CHARGE UNIT BEFORE USE ABOUT 2 HOURS

SPLASHPROOF COVER

Make sure the splashproof cover on the back of the unit is completely flush with the unit by pressing along the entire edge of the cover until it is completely and securely in place.

For questions, full instructions, warranty, and additional safety information, please scan the QR code or visit: www.ihome.com/help/iBT400

FCC Information

This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.

This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

• 
  Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help. CAN ICES-3 (B) / NMB-3(B), CAN RSS216 / CNR-216

IC Statement

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.

This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.

IMPORTANT SAFETY INSTRUCTIONS

This device uses an internal non-replaceable rechargeable lithium-ion battery that should last the lifetime of the device. If you suspect your battery may be dead, try charging it for an extended period of time and try resetting the unit.

WARNING/DISPOSAL OF UNIT

Do NOT attempt to change the battery. Doing so will void the warranty and could cause injury and damage to your device. To dispose of the unit, follow the instructions below:

• Never dispose of used batteries/electronics with ordinary solid wastes, since they contain toxic substances.
• Always dispose of used batteries/electronics in accordance with the prevailing community regulations.
• Many electronics retailers now recycle batteries and other electronic components at no charge

GENERAL BATTERY PRECAUTIONS

• Never use or charge a battery if it appears to be leaking, discolored, deformed, or in any way abnormal.
• Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or other electrolytic substances.
• Avoid charging a rechargeable battery when the temperature is not within 5°C - 35°C (41° - 95°Fahrenheit).
• Never expose a battery to any liquid.
• Never expose a battery to excessive heat such as direct sunlight or fire. Never use a battery pack in an unventilated vehicle where excessive internal temperatures may be encountered.
• Always keep batteries out of the reach of infants and small children.

© 2020 SDI Technologies, Inc.
All rights reserved

iBT400_FCC_121919-A

Printed in China