Advertisement
Thank you for choosing the iZ44 Soothing Sound and Light Machine from iHome. For more information about this and other iHome products, please visit www.ihome.com
This unit ships with the following items. Please check to see that all items are present.
iZ44 speaker
USB Charging Cable
This product is not a medical device and and is not intended to diagnose, treat, cure, or prevent any disease.
Connect the small plug of the included USB charging cable to the USB port on the back of the unit. Connect the other end to a powered USB port.
Press the Power Button to turn the unit ON or OFF.
NOTE:
The last sound and/or light modes will automatically save when the unit is powered OFF.
Charging LED:
Fast flash red = battery low
When connected to USB:
Solid red = charging
LED off = fully charged
In the event of interrupted operation, use the extended tip of a paper clip or other thin tool to press in the Reset button.
Sound Therapy uses specially recorded and engineered sounds to allow your baby to relax. Press any one of three Soothing Sound Buttons (Lullaby, White Noise or Nature) to access Soothing Sound modes. Press and release the button repeatedly to cycle to each mode.
Brahms: Classical music has a soothing and calming effect
Silent Night: An instrumental version of the classic song
Twinkle: An instrumental version of the classic song
Air: Brown noise is a low-toned repeating frequency, like a fan
Focus: Pink noise is a medium-toned repeating frequency, like a waterfall
Quiet: The standard white noise repeating frequency, like radio static
Nature: Springtime woodland sounds
Ocean: Waves crashing on a beach
Storm: Subtle thunder and strong rainfall
Press and hold any of the Soothing Sound buttons (Lullaby, White Noise, or Nature) to turn off the preset sounds.
When any Soothing Sound Mode is active, press the Sound Timer Button as needed to cycle to the desired timer duration: 10 minutes, 30 minutes, 1 hour, and OFF.
Press and hold the Sound Timer Button for 2 seconds to cancel timer mode.
Press the Light Mode Button repeatedly to cycle through 4 light modes:
When Light Mode is active, press the Light Timer Button as needed to cycle to the desired timer duration: 10 minutes, 30 minutes, 1 hour, and OFF.
Press and hold the Light Timer Button for 2 seconds to cancel timer mode.
This device uses an internal rechargeable lithium-ion battery that should last the lifetime of the device. If you suspect your battery may be dead, try charging it several times.
WARNING/DISPOSAL OF UNIT
Do NOT attempt to change the battery. Doing so will void the warranty and could cause injury and damage to your device. To dispose of the unit, follow the instructions below:
GENERAL BATTERY PRECAUTIONS
IMPORTANT SAFETY INSTRUCTIONS
Please heed all warnings, read and follow all instructions and keep these instructions handy for future reference.
FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
ISED Information
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
The device comply with ISED RF exposure requirement, users can obtain Canadian information on RF exposure and compliance.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
For product support information and warranty please visit: www.ihome.com/support
© 2021 SDI Technologies, Inc. All rights reserved
Questions? Visit www.ihome.com
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download iHome Baby iZ44 - Soothing Sound and Light Machine Manual
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the Baby iZ44 that isn't answered in the manual? Leave your question here.