Zontes ZT125/310T-M Maintenance Manual page 50

c. Grasp the rear of the battery cover assembly, turn it up,
and then pull it out toward the rear of the vehicle. Note that
there are buckles on both sides of the front. The rebate
position needs to be inserted in the front when re-installing.
d. Open the black negative protection cap of the main
wiring harness, use a cross-battery or 10# sleeve to remove
the battery's own bolts and move the negative line away
from the battery; then open the red positive protection cap
and remove the positive bolts. Remove the positive wire.
Remove the battery upwards.
Before March 7,2022:
After March 7,2022:
For vehicles produced before March 7, 2022, follow this
step, and for vehicles produced after that, skip directly to
step h.
e. Pull up the 3 fuse boxes and pull out the cables. When
re-installing, you need to insert the fuse box back to the
corresponding position and arrange all the cables, otherwise
it will be difficult to fit the battery cover in place.
f. Pull out the two relay wires.
There are a total of 8 relays, the model is: KH-1A4T.
g. Unplug the two wires of the starting relay. Open the red
and black protective caps of the starting relay, and remove
the nuts with a 10# sleeve.
h. Straighten out the cables in the battery compartment.
For the medels before March 7,2022, remove the M6×16
bolts (3) on both sides with 4# inner hexagon according to
Figure 1, and remove the bushing⑷ and cushion rubber⑸.
For the medels after March 7,2022,remove 2 pcs swell
nails⑵ on both sides.
50 / 188