Campania International YARDART Bebel Pebble FT-361 Assembly Instructions

Fountain Components
Image Item Description
Salinas Pebble
Fountain, Low -
Water Feature
Bebel Pebble
Fountain, Tall -
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Fountain Information:
• Two people are recommended for the installation of this fountain!
• This fountain holds approximately 5 gallon of water.
• This fountain uses a small fountain cover: FTNCOV-SM
• No refill device or submersible lights are suggested for this fountain.
Pump Information:
OEMPF140 - 140 GPH Pump (6 ft cord length)
Tools Required:
Bubble Level
Screwdriver
Component
Quantity
Item #
FT-381A
1
FT-361B 1
Basin
Fountain Set-Up:
FT-361 Bebel Pebble Fountain, Tall
Image
Assembly Instructions
Pump Kit Parts List
Component
PK140 Pump
(use only large adapter)
#10 Stopper
Approx. 25" length of 1/2" black
non-kink tubing
Approx. 1.5" length of 5/8" clear vinyl
tubing
Approx. 1.5" length of 1/2" CPVC pipe
PEBBLES-5
Hose Clamps
Proudly
MADE IN USA
Quantity
1
1
1
1
1
1
1
rev 8/10/21