Page 1
Waste Ensure receptor is well supported. Channels and chases created for plumbing connections must be Support feet must be fully completely backfilled before supported. installation. 201419 , 2007 1072927-T01-A Copyright Kohler China Ltd., 2007...
Page 2
RECEPTOR INSTALLATION 1. Prepare tray. Peel back protective film from back edges of Receptor. INSTALLED 2. Prepare for Waste outlet. Ensure LEVEL that the Waste outlet is prefitted at the centre of the waste outlet 30mm hole in the Receptor. FLOOR LEVEL 3.
Page 3
6. Apply a bead of Silicone sealant to full length at the top and sides of Receptor to seal the joint between wall and Receptor. 7. Install Shower Doors. Follow the instructions suppied with the Door pack. CLEAN-UP AFTER INSTALLATION When cleaning-up after installation,do not use abrasive cleaners as they may scratch and dull the surface.