Advertisement
Quick Links
BEFORE YOU BEGIN
923 mm
283 mm
SQUARE CORNER RECEPTOR
Ensure Receptor is installed on a
flat, level surface, free of any bumps
or protrusion.
If the floor is not level a weak
cement (approx.10:1) can be used
to level the receptor as it is finally
installed.
Ensure receptor is well supported.
Channels and chases created for
plumbing connections must be
completely backfilled before
installation.
1072927-T01-A
923 mm
283 mm
ANGLE CORNER RECEPTOR
Concrete Wall
Tiles
Silicone
Waste
Support feet must be fully
supported.
368
-1-
INSTALLATION INSTRUCTIONS
SHOWER DOOR RECEPTOR
K-17230T-DR/K-17227T-DR/K-17226T-DR
ROUND CORNER RECEPTOR
10 1),
Receptor
201419
Copyright Kohler China Ltd., 2007
923 mm
283 mm
, 2007
Advertisement
Related Manuals for Kohler K-17230T-DR
Summary of Contents for Kohler K-17230T-DR
- Page 1 Waste Ensure receptor is well supported. Channels and chases created for plumbing connections must be Support feet must be fully completely backfilled before supported. installation. 201419 , 2007 1072927-T01-A Copyright Kohler China Ltd., 2007...
- Page 2 RECEPTOR INSTALLATION 1. Prepare tray. Peel back protective film from back edges of Receptor. INSTALLED 2. Prepare for Waste outlet. Ensure LEVEL that the Waste outlet is prefitted at the centre of the waste outlet 30mm hole in the Receptor. FLOOR LEVEL 3.
- Page 3 6. Apply a bead of Silicone sealant to full length at the top and sides of Receptor to seal the joint between wall and Receptor. 7. Install Shower Doors. Follow the instructions suppied with the Door pack. CLEAN-UP AFTER INSTALLATION When cleaning-up after installation,do not use abrasive cleaners as they may scratch and dull the surface.