Setting Of Parameters - Suzuki 990E0-54P56-010 Installers And Users Instructions

CAUTION
The system is factory configured, modify default settings only if strictly necessary!
Par.
01 Volume of buzzer
02 Detection range - Central sensors
03 Detection range - Outer sensors
06 STOP zone - Central sensors
07 STOP zone - Outer sensors
11 Number of speed signal pulses
12 Delay of sensors deactivation
15 Service display (testing)
16 Continuous detection - zones F1 and F2
17
Ref.1: 0 = OFF
1 = Low
2 = High
Ref.2: By setting "00" => the system is activated every time ignition is turned ON.
To disable => press the button on the LED receptacle.
To turn it back ON => press the same button again.
Ref.3: 0 = OFF
1 = Distance from closest obstacle.
3 = Vehicle approx. speed (km/h, refer to parameter 11 to program).
Ref.4: 0 = OFF
1 = ON
Ref.5: 1 = Low
2 = Medium
3 = High
a. To enter in programming mode, press and hold for at least 2 seconds one of the two buttons on the control unit (4).
b. Select parameter "15" (see "Setting of parameters").
c. Press and hold one of the two buttons and select the test: "1" to test sensors or "3" to detect speed.
d. Press and hold one of the two buttons; the display will show "--".
e. Test the sensors; the system will indicate the actual distance.
f. Reset parameter to "00".
g. When testing is completed, press and hold one of the two buttons until the previously selected parameter (15) is displayed.
h. The system will automatically exit programming mode 10 seconds after the button has been pressed.
8

11. SETTING OF PARAMETERS

Parameters
Sensitivity
12. TESTING
SUZUKI GENUINE ACCESSORIES
Selectable Settings
0, 1, 2 (Ref.1)
50 - 95 cm
50 - 95 cm
30 - 50 cm
30 - 50 cm
1 - 99
0 or
10 - 60 sec. (Ref.2)
0, 1, 3 (Ref.3)
0, 1 (Ref.4)
1, 2, 3 (Ref.5)
English_I-M 990E0-54P56-010 Rev00 03/09/2018
Factory Settings
2
90
50
50
30
2
00
0
1
1