Suzuki 990E0-54P56-010 Installers And Users Instructions page 7

CAUTION
Only expert users should modify the settings to avoid malfunctions of the parking system.
The display will indicate:
FS: Factory Settings => Factory default adjustments.
CS: Custom Settings => User-chosen adjustments.
To enter in programming mode, proceed as follows:
Press one of the two buttons on the control unit and keep it pressed for at least 2 seconds:
When the parameter you want to modify is displayed, press one of the buttons and keep it pressed
until the display starts to blink: at this point the parameter can be modified.
Press one of the two buttons on the control unit and keep it pressed for at least 2 seconds to register the value.
The display will stop blinking and the selected parameter will be displayed.
If no button is pressed within10 seconds, the system will exit the programming mode.
NOTE
To reset factory settings (FS), simultaneously press the 2 buttons on the control unit and keep them pressed for more than 2
seconds.
10. PROGRAMMING
the system will activate and enter in programming mode.
Press the LEFT button to go back to the previous parameter.
Press the RIGHT button to move up to the next parameter.
Press the LEFT button to decrease the parameter value.
Press the RIGHT button to increase the parameter value.
SUZUKI GENUINE ACCESSORIES
English_I-M 990E0-54P56-010 Rev00 03/09/2018
7