Hitachi RAS-SX18HAK Instruction Manual page 23

EN̲23.ai 2010-7-7 15:20:05 EN̲23.ai 2010-7-7 15:20:05
MOLD MONITOR OPERATION
The air conditioner detects indoor temperature and humidity. Once the temperature and humidity reaches to a
level conductive to mold growth, the dehumidifying and stainless plasma air purifying operations automatically
start.
C
M
Y • Mold monitoring operation is a preset function. Even if mold monitoring mode is preset, the actual operation
will be performed only when the detected temperature and humidity has reached the level conducive to mold
CM
growth.
MY
• The setting of mold monitoring mode is valid for 2 weeks from the last remote control operation.
CY
(If any remote control operation is performed while
CMY
mode is valid for 2 weeks from such remote control operation.)
Once the above mentioned 2 weeks have elapsed, the
K
off.
(However,
indicator on the indoor unit is off, please reset or cancel the mold monitoring mode.)
• When mold monitoring mode is set, the fan operation is performed for approximately 3 minutes once every
approximately 20 minutes and the room temperature and humidity are detected.
(The movable panel and horizontal air deflector remain closed when temperature and humidity are
detected.)
• In the first cycle of mold monitoring operation, dehumidifying operation is performed for 4 hours consecutively
if the detected temperature and humidity are 10°C and more and 70% and more, respectively. From the
second cycle onwards, dehumidifying operation is performed if the detected temperature and humidity reach
the above mentioned level and will stop once the humidity has gone down.
• For the duration of 20 minutes after mold monitoring operation temporarily stops, the mold monitoring operation
is not performed immediately even if mold monitoring mode remains set and the humidity exceeds 70%.
• There is no function to remove mold that has grown.
Press the
1
(MOLD MONITOR) blinks.
While
towards the unit and press the
2
• Preset the mold monitor operation.
• During the mold monitor operation,
indicators on the indoor unit turns on.
Press the
(MOLD MONITOR) blinks.
While
towards the unit and press the
CANCEL
• A short beep sounds and
on the remote controller.
• The
(MOLD MONITOR) indication on the remote controller remains on. If the
(FUNCTION SELECTOR) button until
(MOLD MONITOR) is blinking, point the remote controller
(ON/OFF) button.
(FUNCTION SELECTOR) button again until
(MOLD MONITOR) is blinking, point the remote controller
(ON/OFF) button.
(MOLD MONITOR) indicator turns off
(MONITOR) indicator on the indoor unit turns off.
(MOLD MONITOR) is set, the preset mold monitoring
(MONITOR) indicator on the indoor unit turns
– 23 –
(ON/OFF) and (MONITOR)
(MONITOR)