Honeywell BW RigRat User Manual page 88

3. Remove the cover over the Serial receptacle.
4. Align the RAEMet's connector plug with the BW RigRat's receptacle using the indexing
keys and slots as a guide.
SERIAL
5. Press the RAEMet's base into place, and then turn the locking ring to tighten the
connection. Never force the connector in or out of the receptacle.
6. Tighten the locking ring until the RAEMet sensor is firmly seated. Do not turn the entire
RAEMet sensor.
If the RAEMet and BW RigRat's receptacle are not aligned properly, electrical connections will
not be made and the RAEMet sensor will not operate. Also, when the RAEMet sensor is not
attached to the instrument, make sure the cover is securely closed to keep moisture and debris
from entering the base.
Note: Do not remove the RAEMet sensor from the instrument while it is in operation.
Note: Keep strong magnets away from the RAEMet sensor. It contains a compass, and strong
magnetism can affect its accuracy.
BW RigRat
SERIAL
Note locations of indexing slots in receptacle
IMPORTANT!
87 User Manual