Turning The Bw Rigrat On And Off; Turning The Bw Rigrat On - Honeywell BW RigRat User Manual

Local area gas monitor

Hide thumbs Also See for BW RigRat:

Table of Contents

CHAPTER

With the instrument turned off, press and hold the button until LCD display starts a countdown,

and then release. During startup, the battery, buzzer, and LEDs are tested, and then it performs

self-testing of its other functions. When the main measurement screen appears, the instrument

is ready for calibration or use.

Note: The type number is given on the LCD display during startup, refer to clause 2 for more

details about use restriction.

Note: When the battery's charge falls below a preset voltage, the instrument warns you by

showing a critical error message, and turn off automatically in 3 seconds. You should charge the

battery before turning it on again.

If a major error that prevents the BW RigRat from functioning is found during startup, the

message "Contact Service" is shown on the display. The instrument should be shut off and

serviced.

Note: During a pumped BW RigRat's startup, startup pauses and the display instructs you to

place your finger over the pump inlet to test the pump. Leave the inlet covered until

instructed to remove your finger.

BW RigRat

Turning the BW RigRat On and Off

IMPORTANT!

User Manual

Table of Contents