Prokan Pro Elite BS04R-BI-LP Assembly Instructions & User Manual page 33

Main Burner Lighting Instructions
1.
Before each use, check all hoses for cracks, nicks, cuts,
burns or abrasions. If a hose is damaged in any way, do
not use your grill before replacing the hose with an
authorized part from the Parts List. Also make sure all
gas supply connections are securely tightened.
2. Familiarize yourself with all Safety and Use and Care
instructions in this manual. Do not smoke while
lighting your grill or when checking the gas supply
connections.
3. Be sure that the LP Gas tank is filled.
4. Open the Grill Lid before lighting.
!
CAUTION
Failure to replace a faulty hose, secure gas supply
connections or to open the Lid before proceeding to
the Lighting Procedures could result in a fire or
explosion that could cause serious bodily injury,
death, or property damage.
5. Set Control Knobs to OFF and open the LP Gas tank valve
SLOWLY 1/4~1/2 of a full turn.
OFF
6. Push and turn Left Main Burner Control Knob to
HIGH) and immediately press the electric ignitor button
3 to 4 seconds to light the burner.
7. If ignition does not occur in 5 seconds, turn the Burner
Control(s) off, wait 5 minutes, and repeat the lighting
procedure. If ignition still does not occur, turn the burner
control(s) and gas source OFF. Wait 5 minutes for gas
to clear and then conduct a leak test of ALL gas
connections and gas sources as explained in the Use
and Care section of this manual. If no leaks are detected,
wait 5 minutes for any gas to clear and repeat the lighting
procedure.
8. After one Burner is lit, turn the tank valve SLOWLY one
more 1/4 of a turn.
Care & Use Instructions
9.
!
Open LP Gas tank
(IGN/
Repeat steps to light each burner individually. Note: When
lighting all main burners, start with the burner furthest from
fuel source location, then light remaining burners in se-
quence moving toward fuel source.
Main Burner
Rotisserie Burner
Rotisserie Burner Lighting Instructions
1. Follow steps 1 through 5 of the Grill Lighting
Instructions.
2. Then, push and turn the Rotisserie Burner Control
Knob to (IGN/HIGH)and hold knob in. Press the
electric ignitor 3 to 4 seconds to light the burner.
Once the burner is lit, continue to hold the knob in
10 seconds before releasing. If ignition does not
occur follow step 7 before retrying.
3. After the Rotisserie Burner is lit it will reach
cooking temperature quickly. The orange/red
glow will even out within minutes.
Side Burner Lighting Instructions
1. Follow steps 1 through 5 of the Grill Lighting
Instructions.
Push and turn Control Knob to
2.
3. The built-in spark ignitor will light the burner auto-
matically.
You may have to push and turn the control knob up
4.
to 3 or 4 times to light.
If ignition does not occur in 5 seconds, turn the
5.
Burner Control off, wait 5 minutes, and repeat the
lighting procedure. If ignition still does not occur,
turn the burner control and gas source OFF. Wait 5
minutes for gas to clear and then conduct a leak test
of ALL gas connections and gas sources as ex-
plained in the Use and Care section of this manual.
If no leaks are detected, wait 5 minutes for any gas
to clear and repeat the lighting procedure.
IMPORTANT: Do not use the Rotisserie Burner
and Main Burners at the same time.
(IGN/HIGH).
33 |
P a g e