Prokan Pro Elite BS04R-BI-LP Assembly Instructions & User Manual page 12

Step 2：
Adjustable Level are located underside of the Island Assembly as shown.
If the Island sets are not level with each others, adjust the 6 preassembled Adjustable
Level using the wrench provided.
- Turn the adjusters clockwise to raise the height of the Island.
- Turn the adjusters counterclockwise to lower the Island.
After leveling, double check for making sure that all the adjusters touch the ground.
IMPORTANT: For illustration purpose the Island Assembly Set is shown on a tilted
angle. FOR YOUR SAFETY, DO NOT TILT your Island Assembly at any time.
Caster Wrench
Step 3：
6 Install Ignitor Battery
Remove Ignitor Cap from Control Panel.
Place supplied AA battery into the Ignitor Slot with positive pole facing you.
Position the Cap and Spring over the AA battery and tighten onto Control Panel.
Ignitor Slot
AA Battery
Spring
Ignitor Cap
NOTE: CORRECT BATTERY USE
•
Always purchase the correct size and grade of battery most suitable for the intended use.
•
Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to battery installation.
• Remove batteries from equipment which is not to be used for an extended period of time.
Remove used batteries promptly.
•
-
+
wrench
12 | P a g e