Troubleshooting - Vela Meywalk 4 Instructions For Use Manual

1.2. TROUBLESHOOTING

Mistake
The gait trainer cannot turn
Brake function does not work
Upper part hangs skewed to one side
Upper part is stuck
The gait trainer rolls badly
The gait trainer cannot be walked backwards
The handle is loose
The seat bracket is loose
The seat height and gait height are lower than before
Trunk support and riser are loose
The seat height is lower than before
If the above does not solve your problem, you should contact your VELA
supplier.
Possible cause and solution
Direction lock may be activated. See section 2.0.16.
The brake is not activated. See section 2.0.5.
Check that both springs are fitted correctly. See section
2.0.2. or 2.0.3.
Check that both springs are fitted correctly. See section
2.0.2. or 2.0.3.
Wheels are blocked. Clean the wheels for wire residue
and the like.
The walking resistance brake may be activated. See
section 2.0.14.
The backstop may be activated. See section 2.0.15.
Tighten the handles
Tighten the handle
Loosen the handle, move the upper part up to the
desired height and tighten the handle again. See
section 2.0.4.
Tighten the handle
The tilt bar is folded down. See section 2.0.10.
E N
7