Table of Contents
Advertisement
Available languages
Available languages
Trouble or fault
Running speed suddenly
drops considerably.
No suction power or reduced
suction power
The product doesn't restart
by itself after the saw blade
has stalled.
The battery does not engage
with an audible click.
Product vibrates more than
usual.
LEDs of the battery show
nothing
10
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11
Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12
Further information
For more information on operation,
qr.hilti.com/manual?id=2276127&id=2276128
This link is also to be found at the end of the documentation, in the form of a QR code.
Originele handleiding
1
Informatie over documentatie
1.1
Over deze documentatie
•
Lees voor ingebruikname deze documentatie door. Dit is vereist voor veilig werken en storingsvrij gebruik.
•
De veiligheidsinstructies en waarschuwingsaanwijzingen in deze documentatie en op het product in acht
nemen.
•
De handleiding altijd bij het apparaat bewaren en het product alleen met deze handleiding aan andere
personen doorgeven.
32
Nederlands
Possible cause
Saw advance pressure is too high.
The chip / dust channel is blocked.
The overload cut-out has been
activated.
The retaining lugs on the battery
are dirty.
The saw blade is fitted incorrectly.
Battery defective
technology,
environment and recycling,
Action to be taken
▶ Reduce advance pressure and
switch the power tool back on.
▶ Clean the chip / dust channel.
→ page 31
▶ Press the switch-on interlock
and the on/off button again.
▶ Clean the retaining lug and
re-insert the battery.
▶ Remove the saw blade and refit
it correctly.
▶ Contact Hilti Service.
follow this link:
2276127
*2276127*
Advertisement
Table of Contents
