Honeywell CO301PC Series User Manual page 16

USE & OPERATION (CONTINUED)
CLEANING THE HONEYCOMB COOLING MEDIA (CONTINUED)
Removing the Honeycomb Cooling Media:
1. Remove the screws from the Front Grill of the Air Cooler.
2. Carefully pull out the Front Grill from the Air Cooler.
3. The Honeycomb Cooling Pad is secured on the Honeycomb Frame that is fixed in place by screws
on the Left and Right Side of the Honeycomb Frame. Remove these screws to release the
Honeycomb Frame Cover.
4. Pull out the Honeycomb Frame Cover and Honeycomb Cooling Pad. Replace with the new
Honeycomb Cooling Pad by put into the grooves of the Honeycomb Frame until it fits comfortably
and securely in place on the frame. Replace the Honeycomb Frame Cover rear back onto the
Honeycomb Frame by replacing the screws and tightening them in place. This secures the
Honeycomb Cooling Pad in place on the Honeycomb Frame.
5. Repeat steps 1 to 4 to remove the Honeycomb Cooling Pad on the Rear Grill.
WARNING: DO NOT operate the Air Cooler when the Front or Rear Grills are removed from the Air
Cooler, or if there is a loose-fitting Front or Rear Grill. Doing so can cause serious injury or dangerous
electrical shock.
Step 1:
Front/
Rear Grill
Step 3:
Rear
Honeycomb
Pad
Step 5:
Honeycomb
Frame
Cover
Step 2:
Front/ Rear
Grill Screws
Step 4:
Honeycomb
Frame
Step 6:
Honeycomb
EN 7
Screws
Rear
Honeycomb
Pad
Pad
Front/
Rear Grill
Honeycomb
Frame