Product Outline; Features - Panasonic ZEQUO 6600RE Installation Manual

1

Product Outline

The ZEQUO 6600RE is a Layer 3 all giga Ethernet Switch equipped with management
functions that has 24 10/100/1000BASE-T ports, 4 SFP expansion ports, 4 SFP+ expansion
ports and 2 40G stack ports.

1.1 Features

 Has wire-speed Layer 3 switching function.
 Ports 1 to 24 are 10BASE-T/100BASE-TX/1000BASE-T ports corresponding to
autonegotiation.
Also their speed and communication mode can be switched by configuration.
 Ports 21 to 24 are SFP extension slots.
These ports and the 1000BASE-T twisted pair cable ports cannot be used
simultaneously.
 Ports 25 to 28 are SFP+ extension slots. They are capable of 10-Gbps
communications. They can be used as SFP or SFP+ ports.
If the stacking functions have been activated, ports 29 and 30 will be stacking ports.

By using the 40G direct attach cables, stacking connections are feasible for up to a
maximum of four units whereas the ZEQUO 6700RE, or the ZEQUO 6600RE are mixed.
 Settings and firmware can be changed and saved by using an SD card.
 All twisted pair ports support straight/cross cable auto sensing function. Simply
connect devices with straight cables, whether it is a terminal or a network device.
(This function does not work if the port communication configuration is set at Fixed
or Link Aggregation.)
 Embedded power saving mode detects the connection status automatically and
saves power consumption to minimum.
The ports which generated the loops give notification via LEDs, and the ports which

generated the loops are automatically shut off via the loop detection and blocking functions.
The ports which generated the loops are displayed via LEDs, and the network manager

can identify the ports which generated the loops after the loop resolution via the loop
history functions.
Triple authentication which can simultaneously wait for IEEE802.1X, MAC, and WEB

authentications at a single port is supported, and an authentication network can be
configured which matches the kinds of connection terminals.
Step authenticating is supported, and user authentications and terminal authentications

can be implemented in phases.
 The Ring Redundant Protocol (RRP) is supported, allowing to make a redundant net-work
via ring topology.
A power supply redundancy can be configured via the additional purchases and mounting

of power modules.
The power modules and fan modules are hot-swappable.

-
7