Table of Contents
Advertisement
NOTICE:
When removing the nut and washers from the battery pole, it will become loose.
This is normal. When the cable is connected and the nut and washers are back in
place it will be tightened again.
2. Remove positive battery pole and fuse.
3. Now the fuse can be checked and replaced with a new one or it can be replaced with a non-
fused battery pole. If the fuse is replaced with a non-fused battery pole then clean the
battery pole with a fine sanding block (scotch-brite). Recommended is to add an electrical
joint compound for better conduction.
4. Before connecting the power cable, the voltage of the battery module needs to be measured
to check if it is the same as the parallel connected batteries. If not then charge/discharge the
batteries separately to the same level.
5. Connect the power cables with the instructions of chapter 8.4.2.
59
Innovation in energy storage
Version 2.3 – 21-9-2022
Advertisement
Table of Contents
