Table of Contents
Advertisement
Prolonged Non-Use and Moving the Printer
Prolonged Non-use
If you ever leave the printer unused for a long period of time, remove the power cord from the wall outlet.
We recommend you consult with your dealer about the additional actions you should take to avoid possible dam-
ages that may occur when the printer is used next time.
Moving the Printer
When you move the printer:
• Move it gently.
• Keep it as level as possible, to avoid spilling toner inside the printer as
shown in the figure.
• The handhold on the right side of the printer doubles as the memory
card slot. Be sure to remove the memory card first, if inserted, before
lifting or moving the printer.
• Be sure to remove all the option units such as the sorter and duplexer
before moving the printer.
If you need to move the printer to another location, remove the toner container, waste toner bottle, and developer
unit. The procedure for removing these is as follows:
1
Remove the toner container and waste toner bottle from the printer. Put the toner container into
the plastic bag in which it was supplied to prevent spilling of toner. Close the cap of the waste toner
bottle tightly.
2
Disconnect the connector of the developer unit from the printer and while pulling the developer
unit release lever, remove the developer unit from the printer (1). Close the protect cover on the
developer unit (2) and put the developer unit into the supplied plastic bag (3).
(1)
Remove the developer unit.
Developer
Unit
Put the printer into the box in reverse order of the
3
unpacking procedure (Refer to STEP 1 Unpacking).
Position the pad as shown in the figure, then place the
toner container and waste toner bottle.
(2)
Close the protect cover.
1. Disconnect
2. Pull
Printer Packing
Carton
(3)
Put the developer unit.
Protect Cover
Waste Toner
Bottle
Plastic bag (supplied)
Toner Container
Pad
25
Go to next page
Advertisement
Table of Contents
