Table of Contents
Advertisement
STEP
STEP
8
Turning the Power Switch On
This section describes the procedure for turning on the printer's power.
During start-up, the language for the message display and status page of this printer
can be selected from English, German, French, Italian, and Dutch.
The default message language is English. For how to change the message lan-
guage to another, refer to the Selecting a Message Language section.
Power Switch
Ready
--- A4 PLAIN
Selecting a Message Language
The default message language is English. To change the message language to
another, follow the procedure described below. If required, your dealer can down-
load major languages other than English, German, French, Italian, and Dutch to
your printer. Please contact your dealer.
GO
CANCEL
MENU
Please wait
1
Switch on the printer's power. The mes-
sage display should indicate Self
test.
When the printer is first switched
on after installation, there will be a
delay of approximately 15 minutes
before the printer gets ready to
print as the developer unit needs to
be filled with toner. During this
period, the message display shows
Please wait (Adding toner).
2
Wait until the READY (
also lit and the message display indi-
cates Ready. The printer is ready to
print.
1
While pressing the ENTER key, turn the
power switch ON ( l ). Keep pressing the
ENTER key until the message display
?
indicates Please wait (approximately
1 minute). The message display should
ENTER
indicate Self test.
2
When the message display shows
Please wait, release the ENTER key.
If the indicator does not light,
check that previous steps were
performed properly.
) indicator is
Go to next page
17
Advertisement
Table of Contents
