Gigabyte R182-Z91 Service Manual page 98

Parameter
Memory Addressing
ACPI
BIOS Setup
Description
Press [Enter] for more options.
NUMA notes per socket
Š
– Specifies the number of desired NUMA (Non-uniform Memory
Access) notes per socket. Zero will attempt to interleave the two
sockets together.
– Options available: NPS0/NPS1/NPS2/NPS4/Auto. Default option
is Auto.
Memory interleaving
Š
– Allows for disabling memory interleaving. Note that NUMA nodes
per socket will be honored regardless of this setting.
– Options available: Disabled/Auto. Default option is Auto.
Memory interleaving size
Š
– Controls the memory interleaving size. The valid value are AUTO,
256 bytes, 512 bytes, 1Kbytes or 2Kbytes. This determines the
starting address of the interleave (bit 8, 9, 10 or 11).
– Options available: 256 Bytes/512 Bytes/1 KB/2KB/Auto. Default
setting is Auto.
1TB remap
Š
– Attempt to remap DRAM out of the space just below the 1TB
boundary. The ability to remap depends on DRAM configuration,
NPS, and interleaving selection, and may not always be possible.
– Options available: Do not remap/Attempt to remap.Auto. Default
option is Auto.
DRAM map inversion
Š
– Inverting the map will cause the highest memory channels to get
assigned the lowest addresses in the system.
– Options available: Disabled/Enabled/Auto. Default option is Auto.
Press [Enter] for more options.
ACPI SRAT L3 Cache as NUMA Domain
Š
– Enabled: Each CCX in the system will be declared as a separate
NUMA domain.
– Disabled: Memory Addressing \ NUMA nodes per socket will be
declared.
– Options available: Disable/Enable/Auto. Default option is Auto.
ACPI SLIT Distance Control
Š
– Determines how the SLIT distances are declared.
– Options available: Manual/Auto. Default option is Auto.
ACPI SLIT remote relative distance
Š
– Set the remote socket distance for 2P systems as near (2.8) or far
(3.2).
– Options available: Near/Far/Auto. Default option is Auto.
- 88 -