Gigabyte R182-Z91 Service Manual page 109

Parameter
eMMC Options
FCH RAS Options
Description
Press [Enter] for more options.
eMMC/SD Configure
Š
– Options available: Disabled/SD Normal Speed/SD High Speed/SD
UHSI-SDR50/SD UHSI-DDR50/SDUHSI-SDR104/eMMC Emmc
Backward Compatibility/eMMC High Speed SDR/eMMC High
Speed DDR/eMMC HS200/eMMCHS400/eMMC HS300/Auto.
Default setting is Auto.
Driver Type
Š
– BIOS will select MS driver for SD selections.
– Options available: AMD eMMC Driver/MS Driver/Auto. Default
setting is Auto.
D3 Cold Support
Š
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
eMMC Boot
Š
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Press [Enter] for more options.
ALink RAS Support
Š
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Reset after sync flood
Š
– Enable AB to forward downstream sync-flood message to system
controller.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
- 99 - BIOS Setup