Installation And Connection - Brandt BMG2115X User Instructions

2 / INSTALLATION

Installation and connection

1. This appliance is only intended for
domestic use.
2. This oven is intended for built-in use
only. It is not intended for countertop
use or for use inside a cupboard.
3. Please observe the special installation
instructions.
4. The appliance can be installed in a
60cm wide wall-mounted cupboard.
5. The appliance is fitted with a plug and
must only be connected to a properly
installed earthed socket.
6. The mains voltage must correspond to
the voltage specified on the rating
plate.
7. The socket must be installed and
connecting cable must only be replaced
by a qualified electrician. If the plug is
no longer to accessible following
installation, an all-pole disconnecting
device must be present on the
installation side with a contact gap of at
least 3mm.
8. Adapters, multi-way strips and
extension leads must not be used.
Overloading can result in a risk of fire.
The accessible surface may be hot
during operation.
Installation Instructions
Please Read the Manual Carefully Before
Installation
Please note
Electrical connection
The oven is fitted with a plug
and must only be connected to a
properly installed earthed socket. The
socket must only be installed and
the connecting cable must only be
replaced by a qualified electrician, and
in accordance with the appropriate
regulations.
If the plug is no longer accessible
following installation, an all-pole
isolating switch must be present on the
installation side with a contact gap of at
least 3 mm.
The fitted cabinet must not have a back
wall behind the appliance.
A gap must be maintained between the
wall and the base of the unit above.
Specific gap size could be referenced
by the diagrams.
Minimum installation height: 85 cm.
Do not cover ventilation slots and
suction holes.
Note:
Do not trap or bend the power cable.
15