CFH 52216 Instructions For Use Manual page 55

- Preheat soldering tip up to appx. 270°C
- Put some tin- solder on the tip
- Let the fluid solder coat the soldering tip all over
Replacing the soldering tip (14):
Before replacing the soldering tip (14) unplug the device and let the device, the solde-
ring iron and the soldering tip cool down completely. Otherwise risk of burns!
- Now loosen the fastening screw according to picture III, remove the metal cover and
pull out the soldering tip (see picture IV).
- Afterwards insert the new soldering tip (see picture V), put over the metal cover and
fasten the fastening screw with your hand (see picture VI).
Assembly of the Soldering station :
- With help of the fixing screw (16) screw together the angle- shaped holder (3) and the
safety holder (1).
- Afterwards stick the angle- shaped holder (3) into the provided slot (6) on the solde-
ring station. Check afterwards if this connection is secure and firm! The angle- shaped
holder can be adjusted both at the left and at the right back side of the soldering
station. To do so it is necessary to turn the holder by 180°.
- The safety holder for the soldering iron (1) can be tilted upwards up to 45° continuously.
- Place the soldering iron (2) into the safety holder (1) and via soldering iron port connect
afterwards the connecting cable of the soldering iron (8) with the soldering station.
- Check that the temperature regulation button (10) is on MIN (minimum) and the ON/
OFF switch (9) is in position OFF (on „0").
- After checking that your electrical source is laid out for a voltage of 230 V, you can plug
in the soldering station.
Start of operation:
Before use check each time if the Soldering station , the soldering iron and the con-
necting cables are not damaged. If damaged do not use it! Use the device solely on a
stable and even surface.
- Switch on Soldering station . (Put the ON/OFF switch to position ON "- ").
- Temperature regulation button (10) is on "MIN".
- Put the change- over switch (15) to position "SET". The LED temperature display „DESI-
RED VALUE" (12) lights up.
- Now set the desired temperature through turning the temperature regulation button
(10). It will show on the display.
- Afterwards slide the change- over switch (15) to the left to the position „READ". The
LED temperature display „ACTUAL VALUE" (11) lights up. On the display (7) you can see
how the temperature changes.
- The LED display "HEATER ON" (13) lights up always when the Soldering station heats up.
When the formerly set „DESIRED VALUE" is reached, the LED display „HEATER ON" goes out.
The „DESIRED TEMPERATURE" is reached and shows on the display (7). Now you can start
working.