CFH 52216 Instructions For Use Manual page 54

manufacturer, customer service or a similar qualified
person to avoid damage.
- Do not carry out any manipulations on the device on your own authority.
- If you do not handle the device carefully a fire could start.
- Do not use the Soldering station close to flammable materials.
- Before use remove all flammable objects, liquids and gases from the working area of
the device. Keep your working area clean to prevent accidents.
- Before use check if the tip is properly adjusted on the device. The hot tip or the slot for
the tip must not get in contact with skin, hair, etc. Risk of burns!
- Make sure that the connecting cable does not come in contact with heat, oil or sharp
edges. Damaged connecting cables can cause fire, short circuits and electric shock.
- Never touch the device, the plug or the connecting cables with damp hands.
- Never immerse the device, soldering iron as well as the connecting cables into water!
- After use the Soldering station must be switched off. Afterwards unplug the device,
place the soldering iron (2) into the safety holder (1) and let the device cool down
completely before you store it away.
- Do not leave the device unattended when in use.
- If the device is not used keep it on a secure place protected from dust and humidity.
- Before use check each time if the Soldering station , the soldering iron or the connec-
ting cables are not damaged. If damaged do not use it!
- During usage provide enough ventilation. Make sure that no toxic vapors or gases are
inhaled. Wear protective clothes.
- After longer interruptions of work disconnect the device from the electrical source.
- National and international provisions regarding security, health and labor protection
must be followed.
Use according to specifications:
The CFH Soldering station can be used solely in a dry interior. The CFH Soldering stati-
on is suitable for a nominal voltage of 230 Volts and must be only connected to groun-
ded sockets. The CFH Soldering station is designed for a multiple use in electronics, in
work- shops, repair shops, for handymen, amateurs, as well as for model constructions.
CFH Soldering station can be used for soft soldering with tin solder and flux. It is also
suitable for micro- soldering works to heavy works on metal sheets.
Other use is not allowed as it can lead to injuries. In such cases the manufacturer is not
liable.
Electrical devices always need a short time to heat up until they reach full performance
and the solder starts to melt.
The soldering tip must be tin- coated during the first heating- up (appx. 270°C) by ad-
ding flux and tin- solder (e.g. CFH No. 52324/52322 solder for electronic components
filled with flux, No. 52329/52327 solder for hobby workers filled with flux, No. 52334
solder for radio connections filled with flux). To do so follow these steps: