Kurzweil K2500 Reference Manual page 65

Parameters (SingleLFO Phaser):
PAGE 1
Wet/Dry 0 to 100%wet
Fdbk Level -100 to 100%
PAGE 2
LFO Rate 0.00 to 10.00 Hz
CenterFreq 16 to 25088 Hz
FLFO Depth 0 to 5400 ct
FLFO LRPhs 0.0 to 360.0 deg
Wet/Dry
Out Gain
Fdbk Level
LFO Rate
CenterFreq
FLFO Depth
FLFO Rate
FLFO LRPhs
NotchDepth
NLFO Depth
NLFO Rate
NLFO LRPhs
N/F Phase
Out Gain
N/F Phase
NotchDepth
NLFO Depth
NLFO LRPhs
The amount of phaser (wet) signal relative to unaffected (dry) signal as a percent.
The output gain in decibels (dB) to be applied to the combined wet and dry signals.
The phaser output can be added back to its input to increase the phaser resonance.
Negative values polarity-invert the feedback signal.
The rate of both the center frequency LFO and the notch depth LFO for the SingleLFO
Phaser algorithm.
The nominal center frequency of the phaser Þlter. The frequency LFO modulates the
phaser Þlter centered at this frequency.
The depth in cents that the frequency LFO sweeps the phaser Þlter above and below the
center frequency.
The rate of the center frequency LFO for the LFO Phaser algorithm.
Sets the phase difference between the left and right channels of the center frequency
LFO. A setting of 180 degrees results in one channel being at the minimum frequency
while the other channel is at the maximum.
The nominal depth of the notch. The notch depth LFO modulates the depth of the notch.
For maximum LFO depth, set NotchDepth to 0 dB and NLFO Depth to 100%.
The excursion of the notch depth LFO in units of percentage of the total range. The
depth of the LFO is limited to the range of the NotchDepth parameter such that a full
100% modulation is only possible when the NotchDepth is at the center of its range (0
dB).
The rate of the notch depth LFO for the LFO Phaser algorithm.
The phase difference between the left and right channels of the notch depth LFO. A
setting of 180 degrees results in one channel being at highest amplitude while the other
channel is at lowest amplitude.
The phase difference between the notch depth and center frequency LFOs. For LFO
Phaser, this parameter is largely meaningless unless the FMod Rate and NMod Rate are
set identically.
FX Algs #156-160: Phasers
Off, -79.0 to 24.0 dB
-79.0 to 6.0 dB
0 to 100%
0.0 to 360.0 deg
Algorithm Reference-65