Intersil ISL6423B Quick Start Manual

ISL6423B Quick Start Guide
1. Download and install the ISLUSBI2CKIT1Z
evaluation board GUI from
http://www.intersil.com/products/deviceinfo.asp?p
n=ISL6423B.
2. Attach one end of the USB cable to the
ISLUSBI2CKIT1Z board and the other side goes to
the computer.
3. Attach the 4-pin connector, which came with the
evaluation board, between the ISLUSB2I2CEVAL2Z
October 27, 2010
AN1582.0
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774
Application Note 1582
board and the ISL6423BEVAL2Z evaluation board
(see Figure 1).
4. Apply 12V to VIN and GND post.
5. In Windows Explorer go to
C:\Program Files\Intersil\LNB Controller Interface
and click on the "usb2i2c.exe". The computer screen
should display the program as shown in Figure 2.
6. Under Device Select, choose ISL6423/6423B and it
should display as shown in Figure 3.
FIGURE 1.
FIGURE 2.
|
Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2010. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.