Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
SECTION 200-255-204
FEBRUARY1992
HANDSET
HANGER
PLASTIC
FIGURE 4-24--REMOVAL OF
ELECTRONIC
TELEPHONE
BASE
FIGURE 4-25-REMOVAL OF HANDSET HANGER
NOTE:
3) Position the HVSWHVSI assembly on the
standoffs inside the base, and secure with the
two screws provided.
It is not recommended to equip electronic
4) Connect the HVSWHVSI PCBs to the elec-
telephones with both Off-hook Cal/Announce
tronic telephone PCB as shown in Figure 4-
and the headset option at the same time.
2a.
5.24 The installation of the HVSWHVSI PCBs has
to be done in accordance with the following steps:
FIGURE 4-26-INSTALLATION OF
MOUNTING BASE FOR WALL-MOUNT INSTALLATION
1) Remove the base as described in Paragraph
5.12.
:
NOTE:
Exercise care when assembling the HVSU
P CB to the HVSl PC5 to prevent damage to
the connector pins.
2) Align the P5 connector on the HVSI PCB with
its receptacle on the HVSU PCB (Figure 4-
27). Apply firm, even pressure to the PCBs to
ensure thatthe connectors mate properly (they
click when mated properly).
5) Reinstall the electronic telephone base and
secure it with its four captive screws.
4-22
Advertisement
Chapters
Table of Contents
