Toshiba Perfecptione Installation And Maintenance Manual page 227

PROGRAMMINGPROCEDURES
SECTION 200-255-312
FEBRUARY1992
When entering DLCP, MDT(Table 12-6), the next
prompt will be:
TN0 (Modify Digits Table
Number)-Specifies the
Modify Digits Table Number assigned to the
defined routes in the Route Tables (RTl - RT6).
The same Modify Digits Table may be used for
more than one route.
Enter: Table Number (1 - 12).
DLT (Digits to be Deleted
)-Defines the number
of digits that are to be deleted from the start of a
dialed number. The system will remove these
digits before prefixing any digits defined by the
digits-to-be-added (ADD) prompt. Maximum: 10
digits.
Enter: Number of digits to be deleted or NONE.
ADD (Digits to be
Added)-Defines the actual
digits to be prefixed to a dialed number. The
.
system will prefix these digits after removing the
number of digits defined by the digits-to-be-
deleted (DLT) prompt. Maximum:, 20 digits.
Enter: Actual digits to be prefixed or NONE.
NOTE:
The following codes are used in response to
the ADD prompt to insert pauses: *I = l-
second pause, *2 = 2-second pause, *3 = 6-
second pause (*X = 1 digit).
TABLE12-6
Modify Digits Table
Load the
DLC2 Utility Program.
When TYPE is prompted, proceed as follows:
':
ITEM
Table Number
Number of digits to be deleted from
dialed number
Digits to be prefixed to dialed numb&
PROMPT
USER ENTRY
NOTE
TYPE MDT
TN0 1 - 12
DLT XX etc., maximum: 10 or NONE
(NONE)
1
ADD
XXXX etc, maximum: 20 or NONE
(NONE)
18.2
Default values are noted in parentheses ( j.
(continued)
NOTES:
1. Default Value = NONE.
2. The following codes are used to insert pauses in response to ADD:
*I = 1 digit = 1 -second pause.
l
2 = I &git = 2-second pause. *3 = 1 digit = 6-second pause.
Ignore line entered.
Backspace.
Stop printing and return to REQ.
Exit program.
12-10