Toshiba Perfecptione Installation And Maintenance Manual page 197

PROGRAMMINGPROCEDURES
SECTION 200-255-309
FEBRUARY1992
TABLE 9-5
Procedure - Station Message Detail Recording (SMDR) Data Block
Authorization Procedure must be completed. If an OK response is received, proceed as follows:
ITEM
PROMPT USER ENTRY NOTE
OK
DMDR
- DISK LOADING -
I
I
REQ 1
NEW, CHG, OUT
I
Trunk Port Number TPN
Account Code Length ACL
Y or N
1 - 12 or NONE
1
I
Special Common Carrier #l DN
I
SPCCl
I
NXXXXXX or 10XxX or NONE 1
2
Special Common Carrier #2 DN
Trunk Group
SPCC2
TGP
NXXXXXX or 10XxX or NONE
2
xx YYY
3
I
TGP
I
NOTES:
1. Y = Trunk Port Number will be printed in the SMDR report.
N = Trunk Port Number will not be printed.
2. SPCC I & 2 entries are the DN of any Specialized Common Carrier (SPCC) used (MCI, Sprint, etc.)
or Equal Access Number (10XxX). Data entered here will also appear in the PAR table in Toll
Restriction (DTOL). (Data that is entered here will not appear in the SMDR output.)
3. Enter the trunkgroup number (XX) and the type of calls (YYY) to be recorded on this Trunk Group:
INC =
OGT =
IA0 =
TOL =
INT =
NONE =
Incoming only.
Outgoing.
Incoming and outgoing.
Toll only.
Incoming -All.
Outgoing - Toll only.
No records.
4. TGP continues to be prompted untilm is entered.
= Ignore line entered.
Backspace.
Stop printing and return to REQ.
Exit program.
Error Codes
Program Name: SMDR Data Block (DMDR)
Error Code
ERMDR 00
ERMDR 01
Meaning
SMDR customer data already exists (REQ = NEW).
SMDR customer data does not exist (REQ = CHG, OUT).
ERMDR 02
I
The account code length cannot be changed if verifiable
account codes are programmed.
I
9-17